FREE DELIVERY over £30
5% Back in loyalty points
1 review for BVC Coils by Aspire
Only logged in customers who have purchased this product may leave a review.
BVC Coils by Aspire
£12.99
Order within days, hours, minutes, and seconds for
Description
The Aspire BVC (Bottom Vertical Coil) coils are 1.6ohm and designed to be used in the Aspire K2 Tank, which is also found in the K2 Quick Start Kit.
The Coils come in a packet of 5 single coils.
Compatibility
Other tanks the BVC coils are compatible in are:
- K1
- ET
- ET-S
- CE5
- CE5-S
Tips on making your coil last longer
Prime your coils
Priming your coil essentially means getting liquid into the cotton on the inside. There are two ways you can do this;
- Take your liquid, and drop a bit into the middle of the coil. Normally, you will be able to inspect the coil and you can see the cotton absorb the liquid. Once you have enough in there, then you’re ready to use it. This method normally works best with larger coils.
- The second method, is filling up your tank with liquid as usual, and then just leaving it to stand for 5+ minutes. This is the method I tend to stick with, as the first method can be a bit messy if you’re not careful, and waiting 5 minutes is not the end of the world!
Do not over-vape your device
Every time you vape your device, the coil heats up to a very high temperature, and you start to dry out the cotton. After 3-5 puffs, leave your device to cool down and reabsorb some more liquid. By vaping it heavily in a short amount of time, the coil will get hotter and hotter, and the cotton will get dryer and dryer, and it wont take long for one of those puffs to burn your coil.
Check you’re using the right settings
Some devices do not allow you to adjust your settings, and if you’re using one of these devices, then this does not apply. If you are able to adjust your settings, then make sure you have it set in an acceptable wattage range. If you take a closer look at your coil, you will see in very small writing, the wattage range for your coil. It will say for example, 7-12W. If you’re still unsure, then start with your settings at a really low amount. You might get no vapour at all, but you want to slowly go up in your settings until you start to produce some vapour. You can keep going up slowly, but once you get to a point where the vapour feels a little bit harsh or too hot, then you know you have met the limit, and you will want to go down a little bit.
Specifications
- Aspire BVC Coils: 1.6ohm
Contents
- 5x Aspire BVC Coils
Jayne Lowe –
Great value for money always buy these!